High-Tech Cyanoacrylate Adhesive

Product specification Cyanolit ® 200 is a very low-viscosity, fast-curing adhesive with... more

Product specification

Cyanolit^® 200 is a very low-viscosity, fast-curing adhesive with good capillary flow characteristics, which allows to be used with the smallest gaps.

Cyanolit^® 200 is suitable for difficult-to-bond plastics and elastomers such as POM, FPM, EPDM, APTK, etc., for the adhesive bonding of elastic components.

Curing takes place without heat supply, pressure or additional activators. The classical one-component cyanoacrylates react with moisture, which is absorbed as a moisture film on the material surfaces, in a few seconds.

The curing speed depends on the gap width and the humidity level. A small gap width and a high humidity accelerate the setting process.

After a short time Cyanolit^® reaches high strength. The material continues to harden 24 hours after gluing. Only after this time is the optimum media resistance achieved.

Technical specification

Resin: ethyl-2-cyanoacrylate

Appearance: transparent

Gap width: max. 0.05 mm

Temperature resistance: -80 to +100 °C

Viscosity: 1 - 3 mPas (non-cured)

Flash point: > +83 °C (non-cured)

Danger class: A III (non-cured) (VbF)

Curing time / Tensile strength:

PVC hard: 3 sec. / 5.1 MPa

ABS: 5 sec. / 5.3 MPa

PA 6.6: 12 sec. / 4.0 MPa

EPDM, APTK, FPM: 10 sec. / n/a

Storage: 6 months at +20 °C, max. 9 months at 0 to +10 °C

Close menu

No additional information available.