+49 (0) 6221-3125-0 (Mon-Wed 8 am - 17 pm, Thu-Fri 8 am - 16 pm)

Bevel Gear made of Zinc die-cast

Bevel Gear made of Zinc die-cast
Bevel Gear made of Zinc die-cast
 
   
Product specification Low-price bevel gears for low to medium load, at short operating time.... more

Product specification

Low-price bevel gears for low to medium load, at short operating time.

These gears have significantly higher load-carrying capacity than plastic gears.

Due to the poorer abrasion behavior they are not suitable for continuous operation.

Bevel gears for shaft angle 90º made of zinc die-cast

Module 1.0 / 1.5 / 2.0 / 2.5 / 3.0 / 3.5.

The bevel gears only run as a pair at the stated ratio

For manual operation at medium torques

Low temperature resistance

Technical specification

Material: zinc die-cast ZnAl4Cu1

Teeth: straight-tooth system, pressure angle 20º

Bores: machined

Tensile strength: 270 N/mm2

Max. temperature: +100 °C

No additional information available.
Viewed